DOUBLE SCREW PRESS & DIGESTER

Home > Products > DOUBLE SCREW PRESS & DIGESTER

 
TANER BIG CAPACITY SCREW PRESS P20 & P25 and FRUIT DIGESTER
 
Taner big capacity press and its matching digester are designed to offer a guaranteed high standard of oil loss performance at <7.8% on dry basis with broken nut <20% and operating at a very efficient of 40-60 running Ampere. Consistent throughput is achieved throughout the operating cycle, where P20 is guaranteed a 20-22TPH capacity and P25 is guaranteed a 25-27TPH capacity.
 
Taner screw press has been used vigorously by users, not only on conventional clone (OER 18-22%); but also with user of clone profile on thicker mesocarp (higher fiber to nut ratio) OER 22-26%; at good recorded performance with no compromised quality and operating parameters.
 
With rapid mass commercialization of palm oil industry, the palm oil mill size has seen a surge from a common 30 TPH capacity design to todays’ 80 / 90 / 120TPH due to economies of scale. Commercially, P20 and P25 double screw press and matching digester are introduced to achieve a greater savings in unit at  lower cost / ton hour-1 basis; reduced number of machines and platform required; lesser inventory in amount of spare parts and greater power savings compares to use of conventional P15. Taner has been a fore runner to design a big capacity and efficient press / digester machine; which most of the time a wrong selection resulted in the total mill capacity bottle-neck.
 
With consideration for old machine replacement, the digester is designed with an easy-to-mount hanger block arrangement to suit to any platform height. At the same time, additional feature like shell bin, manhole, spacious oil collecting pan, hydraulic-operating digester door are introduced to enable a more user friendly operation and easier maintenance work. Taner screw press also has improved design in term of wear trust plate with no lengthening shaft, extended well reinforced tail section to prevent piling of fiber and distortion, and selection of helical spur gear at parallel gearbox for a more robust use.
 
With the introduction of P25, we now have a large number of clients designing and operating mills on 50TPH / 100TPH instead of building conventional 45TPH / 90TPH. Taner big press is priced competitively to support this growing trend in pushing the limit of increasing mill capacity by 11% at a fraction of our machinery cost. This new limit of mill capacity shall greatly reduce cost of investment on per ton / hour.  
TOP